[Illustration: Fig. 4.--Front elevation of Joiner's bench]
Materials.--The cost of these will be, approximately: wood, 12s. 6d.; [12
Shillings. 6 Pence] bench screw, 1s. 6d.; nails and screws, 1s.; or 15s.
in all. It is advisable to show the timber merchant the specifications, so
that he may cut up the stuff most economically.
If the wood is mill-planed before delivery a lot of trouble will be saved,
as no further finish will be required, except perhaps at the top corners.
In passing, one should remark that the boards used should be of the widths
and lengths given; while as regards thickness the figures must be taken as
nominal, as in practice the saw cut is included. Thus a 1-inch board would,
when planed, be only 7/8 to 15/16 inch thick, unless the actual size is
specified, in which case something extra might be charged.
Construction.
The Trestles.--These should be made first. Begin by getting all the legs
of exactly the same length, and square top and bottom. Then cut off two
22-inch lengths of the 6 by 1 inch wood, squaring the ends carefully. Two
of the legs are laid on the floor, one end against the wall or a batten
nailed to the floor and arranged parallel to one another, as gauged by the
piece C, which is nailed on perfectly square to both, and with its top edge
exactly flush with the ends of the legs.
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25